uni air filter

EFI · Jun 25, 2008

Just purchased new uni air filter for my RZR and it will not work,it is 1/2" too long and air box lid will not fasten,according to the part number on the bag it is the right part,has any one else run into this problem?

Thanks

ohiotodd · Jun 26, 2008

push harder its not in far enough

guy48065 · Jun 26, 2008

Watch that the filter collar doesn't creep forward as you tighten the clamp. Keep a finger on the collar where it contacts the metal washer as you tighten and don't over-tighten--just enough that you can't twist the filter on the plastic intake tube.

Johnny · Jun 26, 2008

yep ive had to belt sand a 1/4 in or so off some of them to fit good

fanjules · Jun 26, 2008

I thought there was an issue with UNI filters and the gen3 RZR because there was a dimensional change around the airbox somewhere (same way the KMS intake has different gen1/2 and gen3 fittings).

guy48065 · Jun 26, 2008

The new Uni filter may have been developed using a Gen1 Rzr--which didn't have the metal washer on the tube to limit how far the filter could be pushed on.

And just what IS the difference between the old & new Uni for Rzr?

uni air filter

Our Vendors

Top Contributors this Month

Recommended Communities