We are building two versions of a 1000 cc stroker engine. One with long rods and one with short rods. We will dyno and test both for reliability. We have C.A.T. scanned the head and and are doing the port design on C.A.D. We use to do the silicon mold deal, measure and cut for areas but not accurate enough and takes too long. We will offer 5 axis C.N.C. porting for this engine. I have 2 cam designs in the works. One for stock size engines and one for the stroker.
We will also offer a big bore to go with the stoker that will be 1100 CC. This is the best engine I have seen come out of Polaris. I'm Very excited about this project. Horse Power Numbers will be Big for and engine this size on pump gas. fixed the access. In a hurry to get this done.
Darrell (Powermaxx)
HPD
Edit/Delete Message
We will also offer a big bore to go with the stoker that will be 1100 CC. This is the best engine I have seen come out of Polaris. I'm Very excited about this project. Horse Power Numbers will be Big for and engine this size on pump gas. fixed the access. In a hurry to get this done.
Darrell (Powermaxx)
HPD
Edit/Delete Message
opcorn:
