Polaris RZR Forum - RZR Forums.net banner

Dynamix module - can it be flipped 180 degrees for heater install?

2.2K views 6 replies 5 participants last post by  load97  
#1 ·
Hi all -

I am getting ready to install a heater in my '18 Dynamix.
It comes with a relocation bracket for the Dynamix suspension module.

The module will still face toward the front, but the bracket mounts the module on top, instead of a bottom mount on the stock install.

I know the Dynamix will stiffen the suspension when airborne?
Just wondering if the module rotated 180 degrees is going to effect operation?

Thanks in Advance!
 
#3 ·
Just Curious...

Have you installed a windshield yet?

I put a windshield on my 2018 Dynamix, and put close-able vents in the side of the tunnel, and it gets so hot inside due to the cooling lines and natural heat flow from the radiator...that i would not want any more heat...too hot! I also have heated seats...that I only use for about 15 minutes after going outside the car for awhile. Riding in 25-35 deg weather.

A windshield is a huge game changer in winter/cold riding...a much bigger change in comfort than a heater is imho.

Chris
 
#6 ·
Hi Chris ...can you post a picture of the close-able vents you installed in the tunnel ...and do they shut off completely for summer time riding ?
Thanks I always enjoy reading your posts
 
#5 ·
I can confirm that flipping the module upside down does not create any issues. I think as long as the front to rear orientation stays as intended all is good. I had to relocate/invert mine when I installed my Rockford stereo. I've been this way for about a year and have not had any issues..