Polaris RZR Forum - RZR Forums.net banner

Code 21

32K views 14 replies 9 participants last post by  Rob yeast  
#1 ·
Anyone know how to fix this?
 
#6 ·
Trust me it's the Crank sensor. It sets the point to tells the ECM when to fire spark, fuel injectors, etc. The Synchronization of the the CPS and crankshaft position takes place during the first two revolutions each time the engine is started. If the sensor fails or becomes disconnected for any reason the engine will quit running. It only has to fail momentarly to throw a code. For whatever its worth. If it happens again, clean and reseat the connector.
 
#10 ·
I have a similar problem.
I run into water and mud, after 30 minutes when I speed up the engine sounds like misfiring.
I was at the beach, then I wide open the throttle and speed up with no problem.
When I slow down start doing the same thing loosing rpm and sounds like misfiring.
Check display and shows engine check. The code is 21. I disconnected some sensors and connect them back.

Then run for a while and start doing the same thing.
Any Idea?