Assuming it's similar to 2017 XPT, you cannot see the 2 zerks for the sway bar bushings. They are on the back side and point upward.

Sent from my SM-G930V using Tapatalk

 

Here is a diagram out of the service manual.

Sent from my SM-G930V using Tapatalk

 

Ok I found them thanks guys so only 5 total correct

 

According to my service manual, yes 5.

 

Did you have any problems accessing the grease zero for the driveline yoke from underneath the RZR? Some say you can’t access and others say to remove center counsel and go from the top

 

I just pulled the skid plate there are quite a few bolts but an electric impact makes it a breeze kind of a pita for one zerk but to keep it Reliable it is cheap insurance imo

 

Figured I would have to remove them. Is the zerk at a weird angle? Maybe I can rotate driveshaft and find a good angle to access it and drill a hole in skid plate so it’s easier to service next time. Thanks for the response. I wonder how many people blow it off because it’s not as easily accessible

 

Good info

 

I just crawled under my XP4T 2017 & could not find the zerk. I put it in neutral and rolled it back and forth with my fingers in the holes. Could not feel it at all.

Have a question on checking oil level... Do you put the dip stick in all the way in including the rubber end piece?

Sent from my SM-G955U using Tapatalk

 

You insert dipstick all the way when checking oil. I will see if I can post a picture. You have to remove the front and middle skid plate. You will see the front driveshaft. Zerk is right by the ujoint

 

I can’t figure out how to post pictures. Not sure if it is basic membership or my iPad keeping me from being able to post. Or operator error

 

Zerk

 

found this at a perfect time.. Thank you all for the help.

 

So I got under my car and removed the front and middle skid plate. Wow! Do you think popo could have tried a little harder to hide that zerk? Anywho... Got it greased, rides smoother for sure. The vibration send less. Will be greasing the wheel bearings next

Sent from my SM-G955U using Tapatalk