i run close to those sizes in bighorn on my 50 no proplem ,rears are 11 wide they are on the polaris alum wheels, i ground the motor mount down a few sets of tires ago but it clears fine, i am asumming its just a typo the tires are 26-8-14 and 26-10-14

 

If the 14 in wheels are the same offset as stock, you should be ok. When you get to 27 inch tires then spacers will be needed and/or mod the motor mount.

 

yes was a typo, running the polaris alm. too and you didnt have to run spacers just little grinding on the mount??that would be great can still run my 50' wide

 

mine is a little over 50" with the 11's still fit though all the gated section so should be no proplem, i ground the mount just because it looked close on a different tire i had but kinda feel like it would be a good idea to grind the "extra" off anyway it is not doing anything except making my nervious

 

I have the 2009 aluminum mags. They are offset, but I can't tell you how much.

But I'm running 27.5" tall Pitbull Rockers.

No problems. The only nuisance is that at full steering wheel turn, the front tires rub the inner fender well...but only for a few seconds. Nothing I worry about!!

Pirate

 

Thank you

 

If you have the Polaris 14" aluminum mags...that have offset, you will find that even with the big tires, you'll have about 2" clearance on the right side motor mount.

No need for grinding at all.

Now, with my 27.5 rockers, I did put on SLP 7/8" spacers in the rear. Then moved the air cleaner to the bed, and the spacers on the shelf!

Pirate