Polaris RZR Forum - RZR Forums.net banner

1 - 13 of 13 Posts

·
Vendor
Joined
·
5,057 Posts
Discussion Starter #1
I worked a Group Deal this week on the Sandcraft Bearing Carrier. MSRP is $240. If interested please comment below or PM me as we can not post Pricing due to MAP. This Sale will run until Monday morning. Need 10 to make it happen.

Sandcraft Motorsports has once again raised the bar! With over 1 year of testing we are proud to announce the brand new GEN3 RZR carrier bearing. We have created and patented this new design to be a GREASABLE bearing while having 3 layers of protection to keep dirt, sand, mud, and water out. Our all new auto set angle & 2 piece design will lower installation time dramatically. Auto set angle has never been easier. It allows you to press the bearing onto the shaft and install with minimal effort.

Side loading the bearing leads to pre-mature wear and failure. The auto set angle eliminates this from happening to your car. We are the ONLY COMPANY in the world with this design so don’t waste your time with the copycats.
 

Attachments

·
Premium Member
Joined
·
433 Posts
I ordered this and have not received my shipping info or my bearing. This is my invoice #4445. I have called and your mailbox is full. I have email and no response. I have contacted y'all on Facebook and again no response. I paid for this on 7/11/17. Please update the status of my order.
 

·
Registered
Joined
·
155 Posts
Same here. I ordered and asked them not to send till Monday the 24th as I was out of town. My order # is 4447, I also called and mailbox is full and no answer on their phone.
Wonder what gives???
Hello JT!!
 

·
Registered
Joined
·
1,039 Posts
It just showed up. I think the group buy when from 20 people to 200 people. So sending out tracking to every person would be time consuming.
 

·
Registered
Joined
·
182 Posts
I don't suppose that you would have anything for my RZR 800 4? I need a new two piece bearing in a bad way.
 
1 - 13 of 13 Posts
Top