Those look nice. I think I'll be getting one
RZR 900 XP Rear Hitch.
3
Sneak peak pre sand blasting and powder coating, and showing off the heavy duty welds and heavy duty.....EVERYTHING!
This will accommodate a standard automotive draw bar and the gussets are made so you can use them as tie down points or tow points. Everything is 1/4" thick steel and welded from both sides of the plate. The Receiver is made with 1/4" wall Hitch stock, not just thin C Channel with a thin bottom plate welded in to close it off.
I'll post more pics after powder coating, I plan to coat 1 in red and 1 in black for starters...
![]()
![]()
![]()
This will accommodate a standard automotive draw bar and the gussets are made so you can use them as tie down points or tow points. Everything is 1/4" thick steel and welded from both sides of the plate. The Receiver is made with 1/4" wall Hitch stock, not just thin C Channel with a thin bottom plate welded in to close it off.
I'll post more pics after powder coating, I plan to coat 1 in red and 1 in black for starters...
