RZR 900 XP Rear Hitch.

3090 Views 8 Replies 4 Participants Last post by Rubberdown, Jan 23, 2012

Rubberdown

Discussion Starter · Jan 17, 2012

Sneak peak pre sand blasting and powder coating, and showing off the heavy duty welds and heavy duty.....EVERYTHING!

This will accommodate a standard automotive draw bar and the gussets are made so you can use them as tie down points or tow points. Everything is 1/4" thick steel and welded from both sides of the plate. The Receiver is made with 1/4" wall Hitch stock, not just thin C Channel with a thin bottom plate welded in to close it off.

I'll post more pics after powder coating, I plan to coat 1 in red and 1 in black for starters...

See less See more

Save

1 - 1 of 9 Posts

BarRZR

· #5 · Jan 23, 2012

Very nice, professional fab-work, Rubberdown, but you're WAY overkill on your material thicknesses (by a factor of about 2), which only adds weight. 1/8-inch A-36 would be more than adequate for pulling up to 10,000 pounds! What are you going to pull, locomotives? My two-bits......

Cheers

Save

1 - 1 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month