Polaris RZR Forum - RZR Forums.net banner
1 - 7 of 7 Posts

·
Registered
Joined
·
428 Posts
Discussion Starter · #1 · (Edited)
I have done a DIY turbo system. Where is the best location to route the valve cover vent tube. At this point it runs up thru a existing hole in the bed and a breather filter attached. I think a canister would work better. Any ideas are appreciated..
 

·
Registered
Joined
·
15,386 Posts
I have seen where people use a small air compressor filter as a catch can also.
they have a clear bowl so you can monitor hom much/what is coming out of the breather valve.

 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top