Polaris RZR Forum - RZR Forums.net banner
1 - 11 of 11 Posts

· Registered
Joined
·
65 Posts
Discussion Starter · #1 ·
So, we're going to the Sand Sports Super Show to get our 'G pass' and see some other stuff/folks and as we go in, there's Pro Armor's booth... They're showing off their new Quickshot Jack system... Wow, really slick set up. I was looking at the UTV version of a Hi Lift, but since we're in the sand about 50% of the time, I'd need a big foot pad (Quickshot is built on) plus there's all kinds of mounting spots for other equipment. SO, I had to have one.

I'll post picts of it next week, on our trip to Marysvale...

Good job guys! :pint:
 

· Premium Member
Joined
·
505 Posts
Quick Fists! One of the greatest mounting systems that I never thought would make it to the Rzr.

What's the maximum lift of the scissor jack?
Collapsed height of the jack on the QuickShot base is only 5"

The maximum lifting height is 21". Perfect for use with LT suspension while allowing you to not only get the flat tire off the car but get an inflated one back on.

A pair of Quick Fists is included with each QuickShot!
 

· Registered
Joined
·
65 Posts
Discussion Starter · #11 ·
WHOOPS!

Question: Has PA changed the scissors jack to a beefier type? I know this was one of the first sold... I found out that the stamped steel cogs at the bottom of the the jack don't hold so well. I have used this without any problems whatsoever till this past week in the dunes. I was changing out to paddle tires and as I got one tire off the jack just lots it's grip and bent over. Bent the screw, the cogs at the foot of the jack popped out of sync. Glad this happened at camp, and not on the trail.




So is there a beefier scissors jack? I did use my truck jack afterward to finish the job. Noticed how small, lightweight, and it got a double ram height, so it would jack really high despite the bottle being short.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top