Polaris RZR Forum - RZR Forums.net banner

1 - 4 of 4 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1 (Edited)
I have a 2009 RZRS and was climbing out of the the red river on a high embankment and hit a lip at the top I heard a pop and and lost the drive line.
I had to be pull back to the truck. After working today I will start tearing into it.
I was hoping it will just be a belt. But I pull the breather tube off on the trail and was able push on the belt it did not fill like it was broke. I will pull the cover off and check if it is the belt or Clutch. It is like the driveline is in (N).

Any help would be nice.

I pull the clutch cover and the belt and clutch are working fine. I pulled the drive clutch off and the input shift just spins in gear or not.
Must be the transmission.
:sad:
 

·
Registered
Joined
·
38 Posts
Discussion Starter #4
I pulled the motor,trans and diff and open up the trans. The shaft pinion 20 T 3234558was broke in half. It is a easy fix. I will have to press new bearings on the end. The shaft cost $135 everything about $200

Browndog
 
1 - 4 of 4 Posts
Top