Polaris RZR Forum - RZR Forums.net banner

1 - 9 of 9 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter #1
I just purchased a 2010 Razr S, and bought 4 HID's and a light bar for use in glamis and other desert places. My question is each HID came with a 20 amp fuse, when I wire them up does each light need a 20 amp fuse attachted, or can one fuse supply all 4 HID's?

I am new to auxillary HID's and not exactly sure how much power they will draw when being started and while running.

Regards
Brian
 

·
Registered
Joined
·
3,114 Posts
Id run a relay also... always error on the safe side....... Damn thats a great avatar! No cowbell needed.
 

·
Registered
Joined
·
860 Posts
now a days they make good toggle switches to where you dont need relays. Relays are for running higher current circuit with low current circuits. Jmho. Just run a good high quality 20 amp toggle switch. Like I said Jmho
 

·
Registered
Joined
·
55 Posts
Discussion Starter #9
I was planning on running a relay, figured it couldn't hurt.

But will look into a good quality toggle switch also

Thanks everyone
 
1 - 9 of 9 Posts
Top