Polaris RZR Forum - RZR Forums.net banner

help with code 84 2 and speedo jumping

50K views 11 replies 5 participants last post by  Dman1418  
Ok, so just had this issue on a 2020 razer 570
After going thru speed sensor etc. This is were I'm going to send you for fixing this issue.... driver side ecu connector passenger side wire lom splits and goes three directions....rubbing on the frame...this grounded the signal wire,,, I also had a fan constantly on there were three wires effected after fixing wires and securing wires...
Poof fixed
 
Not exactly sure whats going on.

was out on the trail couple weeks ago and had the steering light and code come on and would lose power steering intermittently and not completely go into limp mode but would hesitate upon initial acceleration. My speedometer would also jump random like run up to 45mph when Im going 20 and come back down.

somebody in our group mentioned they had that problem right before their VR went out so I had one with me - changed it out on the trail and seem to be staying right around 14.1 or so at idle. It didn't pop too many more codes for the rest of the day but the speedo would still bounce weird and every once in a while be sluggish on takeoff.

got home plugged in my dynojet and it happened to pop the code and read 84 / 2.

for the most part now the codes not usually on - and I can drive it but it does still hesitate upon initial acceleration. I thought I read that it could be the speed sensor and I did go through a big puddle on that side so I pulled it - didn't see any moisture but let it dry out all day in the sun and put some dielectric grease in there but hasn't really helped.

any suggestions?
I just fixed this on a razer, disconnect ecu wiggle connection to passenger side, I'll bet you here relays chatting.. the wire looks splits three directions found it shorted signal wire