Polaris RZR Forum - RZR Forums.net banner

Desertcraft filters are here!!!

9637 Views 50 Replies 14 Participants Last post by  Desert Molding Concepts/ Desertcraft
Two years ago we set on a quest to develop the best air filter on the market. After several medias and independent testing we realized a combination of medias that met or surpassed the best the industry has to offer. Not only did we have the goal of offering the best filter on the market, we wanted it to be serviceable.

Having an extensive background in industrial facilities and manufacturing allowed us to think out of the box when it came to developing our filter. Severe duty filtration is nothing new in the manufacturing sector, protecting tight tolerance equipment such as turbine generators, compressors and alike is key to the longevity and extended service life. Knowing the investment that many make in their UTV's and the severe conditions that can be encountered, we wanted our customers to have the same protection that is afforded to high end industrial equipment.

While other companies concentrate on getting better flow numbers we concentrated our efforts on all out filtration! Please be cautious if a company states that their filter flows better than brand X. High flow comes at a cost, and typically equates to less filtration. If you're trying to shave a 1/10th of a second of your drag strip run then a high flow filter might be for you. If you are looking for a filter that provides superior filtration to protect your investment, then we would like you to consider our Severe Duty Desertcraft filter.

The Desertcraft filter is a dual component dry filter element that needs no special cleaners or oils. For a quick service excess dirt can be tapped off, and compressed air can be used from the inside out to further remove debris. For a deep clean, the element can be rinsed from the inside out with a garden hose, once its soaked simply spray a diluted solution of dish soap or Simple Green on the pleats and let soak a few minutes. Final rinse from the inside out and let dry completely before use.

Key Features......
 Industry leading combination of filter medias for superior filtration

 Dry element that can be serviced and needs no special cleaners or oils

 Stainless Steel exterior wire mesh support for a durable finish and unmatched strength (Most companies use no support or flat stamped steel with a painted finish)

 Internal fine wire mesh maintaining total integrity of the media layup (Went the extra step here)

 Only filter on the market that has a studded end and mounting bracket for a bullet proof / fail safe installation. (Brackets available as an option)

RZR XP1000/XPT/Turbo S Air Filter

Feel free to reach out to us if you have any questions


See less See more
  • Like
Reactions: 5
1 - 3 of 51 Posts
How about one for the 900Xp, there is still a lot of us out there and will be for a long time.
How about one for the 900Xp, there is still a lot of us out there and will be for a long time.
That's a tough one, Worked with R2C to develop that filter and had a lot of rejects and problems. Once we got them worked out, they just couldn't deliver.

We actually made a nice set up for the XP900 using the stock filter in conjunction with our Super Seal Gasket, Foam Buddy Prefilter and Double Down Intake kit. Works great and have had several customers feed back that they get several hundred miles of service out of their stock filter and only service the Foam Buddy. You can find them at our online store....
I have your foam buddy, works ok, kinda messy to clean and it has to add some resistance to air flow. Would rather just have one filter.
Are you going to make one for the Honda Talon? I will be needing one.
1 - 3 of 51 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.