Polaris RZR Forum - RZR Forums.net banner

Check engine light after installing stereo

4.4K views 10 replies 5 participants last post by  jackedf150  
#1 ·
I just got done installing my SSV Works under dash stereo kit with subwoofer & door speakers. As soon as I fired it up after completing, my check engine light came on. At first it was fairly hard to start or idle, now it will idle but will not accelerate. When I give it throttle it bogs down after about 1/3 throttle. This is a brand new machine so I'm sure it is something I did, but I am lost at the moment. It is going to the dealership first thing in the morning unless I find out how to fix it tonight, so any advice is appreciated.
 
#7 · (Edited)
Follow the wires off tge vane sensor that it attached just above the throttle pedal. Its just 2 little wires in some black wire loom that plug into the a plug coming out of the main harness that goes through the firewall kinda behind the speedometer. When i put my stereo in i managed to push the main wiring harness up and it pulled the wires out of the plug. A good way to tell is go drive it and if sounds like its on the rev limiter at 15 mph you did the same thing i did. Whe i put my under dash sub in i had your exact problem.