It needs it!

 

anyone


Sent from my iPhone using RZRForums.net mobile app

 

I was looking it over at the dealer ( waiting for mine to arrive) and it appears to be an easy fix. I plan to snorkle it to the drivers side close to where the rear part of the cage comes into the bed. Lots of room, out of the way, and nowhere near any of the exhaust or other heat.

 

I was thinking about putting it through the access panel between the seats.

 

You don't want it there unless you are driving around on a Glacier all the time. That air is hot. If you are concerned with that you should snorkel the whole machine. Engine, all vent tubes, belt intake, and belt exhaust. I don't know of any kits available yet though.

 

I've snorkelled my machine fully the intakes are easy just extend. And plug the drain on the air. Clutch exhaust. I went to a 3" abs out to a t. And went down to 2" with rubber reducer Heavy duty rubber hose up beside my intakes. And abs up from there took me 2hrs to do

Sent from my iPad using RZRForums.net

 

Looks good thanks!

 

Went to Auto Zone, bought 2 1/2 stainless flexible exhaust pipe for 24.00 , went to home depot and purchased a 3 x 2 rubber no-hub for pvc pipe and the project is complete.

 

Muduck can you post pics?

 

I'd like to see some DIY belt exhaust snorkels also!

 

Are there any kits for this out? All I want is the exhaust to be as high as the intake. I just received the new clutch cover as well I figured a good time to fix the low exhaust port aswell

 

lets see more pics of others relocation areas.

 

Any others?

 

Heres mine its homemaid but works