I'd like to install a real tach with 3" or 4" dial and needle that I could read at a quick glance instead of having to focus on the digital readout.
Is there such a thing for the RZR?
Is there such a thing for the RZR?
Vinman
Good question.
I am guessing that you would have to tie into the stock CPS, crank position sensor...
My MCX display can show rpm and record it in a log, but it is a digital display too.
I am guessing that you would have to tie into the stock CPS, crank position sensor...
My MCX display can show rpm and record it in a log, but it is a digital display too.
IMO that is the layout the stock display should have. I've been dreaming about getting one of those Dakota Digital units since they came out.
That's what I was worried of. Thanks for the info.
Yes the stock tach is notoriously slow.
I have run data logs up hills where the stock tach says I am maxing out at 6200rpm and the data log will be more like 6400... I can't remeber exatly how far off it was but most the MCX owners that have the data logger will tell you that the stock display is off by 100 or 200 rpms.
I have run data logs up hills where the stock tach says I am maxing out at 6200rpm and the data log will be more like 6400... I can't remeber exatly how far off it was but most the MCX owners that have the data logger will tell you that the stock display is off by 100 or 200 rpms.
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
