I dont think they will cover it under warranty

 

Just tighten it up....you should always check your lugnuts before your first ride and after a short ride to ensure they are tight. you should also grease all of your grease fittings also check your ball joint clamps on your front end and if loose tighten them as mine where loose on mine from the factory.

A lot of pre maintenance needs to be done to these machines before riding as Polaris doesn't do very well setting them up properly from the factory

 

With only 2k miles I would take it back to the dealer, no way should a lug nut be loose yet!!! lmao

 

i would just sell it and buy a new one.

 

Agree! Just buy a new one!:rofl3:

 

I would put it in neutral and rev the hell out of it. This works best between 1 and 5 am on gekko rd in glamis. You may have to keep doing this for an hour.

 

Take the owner to the ER......Immediately:rofl3:

 

Do you have insurance? It might be totalled.

 

Usually the loose nut is behind the wheel, not on it.

 

well played

 

I think you get lemon car !!!!
milos

 

Yours must have been built on a Friday afternoon. You better jump ship and buy a Can Am!

 

Don't know if serious?

 

If the lug nut is loose,obviously you torqued it according to the manual recommendations.:rofl3:
If you take it to the dealer,get a video of it,post it on you tube and then post it here.
There is no sense in the dealer being the only one getting to laugh at you.

Doug

 

OP, very good post, you woke up all the monday morning wise guys, it will probably carry them at work all the way to friday. LOL

 

Huh, I see where you going with this, after the comments some made yesterday you are proving a point?

http://www.rzrforums.net/rzr-xp-900/99083-2-miles-xp-i-got-flat-any-options.html

 

Classic!

 

Why are you worried about 1 a loose lugnut. I'm sure the other three will hold your wheel on so you should be good for another 6000 miles before the wheel falls off. LOL

 

INrider is the winner. This was just poking fun at people. On a serious note, always check those lugs especially on aluminum wheels

 

And people say I don't pay attention....:rofl3:, that was a good one....

 

That thread actually turned out to be interesting.
I hope the guys spills the beans on who the dealer is.

Doug

 

You have a LEMON!!!

Take it back LOL

 

 

Options?

I see only two (2)...
1) Tighten it up.
2) Leave it alone.

:drive1:

 

You guys are plain mean :rofl3::rofl3::rofl3::rofl3:

 

Just wait a second...how do you know it's loose?

Try offering to buy it a drink and see what happens That's the only way I know for sure to tell if it's loose or just teasing!

 

Saw this thread for a while now, right next to the flat tire thread, and from the titles ignored them both till now.
Don't know what made me finally open that thread, and then, to add insult to injury, opened this thread. I knew better, must be the flu I got...

:rofl3::rofl3::rofl3: