Search Results for ‘transmission’

Im looking for the part numbers for the parts necessary for the 36%/21/21 reduction on a 2022 pro xp 2 seater. Do mostly East TN riding, like windrock and Tackett Creek Also, since ill be doing a reduction, is there any thing else i should replace or change when i got the trans open Thanks Guys

2016 1000s, complete new clutch system. Problem is this awful ratcheting, grinding rattling noise when the clutch free wheels at almost any speed unless it’s extremely slow. I do have a bad rear driver axle. Not sure why that would happen when the clutch free wheels though. I’ve checked the...

I recently broke the snorkel gear on my 2017 xp 1000, I noticed that the 2021 snorkel gear, pinion, and snorkel shaft are a new part number. Does anyone know if the 2021 parts will work in the 2017 transmission?

Hi, I had a problem with my 2014 RZR 1000 XP EPS transmission yesterday and am looking for any help to diagnose. Before I begin, I know without pulling the side of the gearbox off it is really impossible to diagnose fully. I guess I am just curious if anybody has had this issue or is aware of...

2013 s 800 Shifter moves freely in & out! What is wrong? What do I need to do to fix? Do I have to remove transmission again? I just finished the re-install as I removed engine & transmission to replace all transmission bearings, now this after I have everything hooked back up.

I need to replace my transmission. Any recommendations. I've found Rev6 and Super ATV. Has anyone had any experience with their transmissions and/or other ones? I know I want the double roller reverse and most likely will end up with a 12%ish reduction.

Hey guys, just had the tranny replaced on my 2016 rzr and noticed this nipple with no hose on it. It’s on top of the transmission. Looks like an air box.

I have a 2016 S 900 I just bought it at an auction, the speedometer is not working for me. I think I've read every forum on here about getting it to work and nothing is doing it for me. I have replaced the sensor, and verified all the wiring from the sensor connecter to their termination...

I recently just bought a 2016 Polaris RZR 900S EPS Transmission for a steal (would not go into forward/reverse) Come to find out the entire transmission is grenaded. I was curious if anyone knew a cheap place to buy a completely new transmission. Also what other years of transmissions will fit...

I just bought a 2015 rzr 900s and last night I drove a piece of rebar through the tranny right where the snorkel gear is I was looking online to see if I could just buy that side of the case and replace it, all I found were cases for a 1000 or 1000xp is the any way I can make that case work for...

I bought a 2015 xp 1000 with 1200 miles on it, test drove it on the guys property and it seemed good. Took it out on some dirt roads by me and went full throttle for about 12 miles still good. Planned a trip up north so I changed all fluids and cleaned air filter, noticed some metal shavings in...

Looking for a transmission for a 2015 rzr xp 1000 4 seater.

My transmission had been pretty hard and getting harder throughout its life to get in and out of gear so I decided looking at the manual to take the inner detent sleeve out and see if i could get the spring and ball and see if anything was wrong. I thought since I was rebuilding the rear end...

Hey guys, new to the sxs community and looking for a little advice... I was just taking the kids around the neighborhood this weekend and when i went to back up and turn around the bike was locked in H, I tried to force a little but didn't want to break it.. I disconnected shift cable to test...

I have a 2015 Polaris rzr 900s. I went out riding this weekend and had a little trouble with the transmission popping out of low gear. It’s more of a grinding noise when letting off the gas. High gear is fine. We tore the transmission down and the gears are in immaculate condition. Replaced some...

I have a 2016 RZR 900s. Broke my reverse chain so I just got done installing a Specialized ATV super single reverse chain and input shaft and also the HD Pinion Bearing retainer plate, checked all my bearings and gears and everything moved, sounded, and looked fine so I didn’t replace any gears...

Bought a used 2014 rzr 170... wouldn't start so I cleaned the carb and re-jetted. It starts and runs now. But doesn't sound great and it is grinding into gear then sometimes will finally catch in both forward and reverse. I tried adjusting the idle screw as mentioned on these forums but I can't...

Went on a ride 4 weeks ago and put the XP through it's paces. All good, but bent lower radius rods. Cleaned up everything afterwards and drove it around to throw out all the water and everything worked fine. Ordered arms from Alba last week and went to push the 900 out of the garage to work on...

I recently found myself with a broken reverse chain and now trying to get the transmission out to repair. Does anyone have any tips on removing? Unlike the XPs there is a bar keeping it from coming out the side. Watched many videos on the XP removal but there is not much info on the S models...