Hello everyone i just installed the the highlifter lift kit and tried to put my 27in mudzilla's on and they will not clear the motor mount on the passenger right side. anyone out there know what size wheel spacer i need to use to get it to clear?


PLEASE HELP

__________________
2008 GREEN RZR
PERF BELT
PERF CLUTCH
2'IN HIGH LIFTER KIT
29.5 SWAMPLITES
PRE RUNNER BUMPERS
SKID PLATES
SIDE BARS

i am surprised no one can help

I would assume a 1and1/2 inch spacer should work, but dont know how much worse the lift kit makes the motor mount issue. It also depends on wheel offset and things.

1 1/2 spacers are fine and i changed the tires to 291/2 swamplites. the mudzillas were way to wide on the side....

I put a 2" lift in my Rubicon it was just shock extenders. What is the RZR kit consisting of. What was the price? Sounds like a easy fix for mud tires. How is the ride.

The H/L kit is the same shock extenders and i think i paid like 225.00 for it. it took about an hour to put on and the ride is not to bad.

I have the same lift. highlifter took extra time making this lift i think its a good thick lift that will hold up. i also installed hunterworks front spring spacer. this gives you 3 inch's of lift. and your tire wont rub fender well in turns. lift cost $259 and spring spacers cost $65. the best way to set up your tire and rim combo is to use a -43 off set. this way you wont need wheel spacer's. and it will give your rim a deep dish that killer.

did you put the swamplites on stock wheels with the spacer, or aftermarket wheels? if aftermarket, which ones? the reason i ask is because i ordered some of the ITP's that make is 4 inches wider overall for my 28x12x12 rear and 28x9.5x12 front MST's. tryin to figure out if i'm gonna need the 2 inch lift or not since i will still end up airing it out sometimes.

when i put my 27 inch tires on without highlifter kit thay rubed. in sharp turns under power.