Polaris RZR Forum - RZR Forums.net banner

570 Height question

5K views 8 replies 7 participants last post by  teamhog 
#1 ·
Good day

So I am thinking about selling my daughters 170 and buy a 570. The issue I have is the height. Currently my enclosed trailer opening is 62 inches. I believe the height of the rzr cage is 69 inches. Is there anything that could be done to cut the height? Not fitting in the trailer is a deal breaker as the trailer houses 2 other ATVs

Thoughts?

Thanks
 
#5 ·
There are places selling custom cages; also, a few people handy with a torch and pipe benders are constructing or modifying their own.
 
#6 ·
My enclosed is the same height as yours. When entering the trailer you will find that the cage will be in before the rear wheels are completely up the ramp. I have a hard top that I have to remove for the clearance. If you have doubts take the trailer to dealer and give it a try.
My trailer is an Interstate 6X10 and it fits ok. A little tight on the sides but I can get in to tie it down.
Denny:redrzr:
 
#8 ·
I have a 10 x 6 with the same problem, I have to remove the roof but what I did find out is if you keep the front of trl. level or a little bit low you have a little more room because of the slant of the ramp puts your rear wheels a little lower and the top bar is already in.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top