Polaris RZR Forum - RZR Forums.net banner

XP 900 Gates C12 Belts scarce, get yours now!!

6K views 10 replies 5 participants last post by  Hunterworks 
#1 ·
I just ordered every belt Gates had for the XP 900, this part number has sold more than accounted for.

Their order system showed zero but I called and the rep said there were 19 floating around. I have a few on the shelf and these coming but that will be it for about 4 weeks according to the rep.

If you are in need of one, we presently have some and are going to hold a few for clutch kits.

So I think we can sell about 15-20 of them before we need to hold a few for kits.

Same price we are not going up, click link below

http://www.hunterworks.com/inc/sdetail/46309/52235

Todd
 
#3 ·
Todd,
Last I heard the stock Polaris belt was the most durable at that time (1yr ago) is this something that has exceeded the Polaris belt ?? Price sure is attractive ��


Sent from my iPhone 4s using Tapatalk
Man, where have you been??? LOL

This is our number one selling belt, lots of guy on here have these. So far great luck. Only people hurting them is people who have a set of conditions that would hurt any belt.

I personally think they are better than the stock on and the price is sure right. Don't let the less expensive price fool you, I get them at a good deal and I pass that on.

Todd
 
#4 ·
if you read any of this read the whole thing please!!


I put my first gates belt on did the slow a$$ 29 mile break in, let it cool every 10 to 15 min, got to 29 ish miles got into 3/4 to full throttle for another 1.5 then after 31miles got into it and hit the rev limiter.. went back to camp checked everthing. belt seemed glazed. cleaned sheaves for the second time even scothch brite to the sides of the belt went back out and still bouncing on the rev limiter... kinda pissed so I went back in swaped to another new gates belt.. went 4 miles at 1/3 to 2/3 throttle and hammered it with no problems... so now I have gates belts on my buddies jagged x, another friends xp with clutch kit, muzzys, fuel controller and intake, my xp with about the same. an xp 4, and a bone stock xp with no other problems we all did a 3 to 5 mile break in.
I put over 200 miles on the belt in 3 days at the dunes and still looks great

oh AND TODD>>>>I need 2 more before the end on the month for dunefest.PLEASE
 
#6 ·
Sounds good and thanks,

I got busy contacting all my contacts at Gates and they are going to expedite production on this belt. Just no ETA on when.

I have some now but at the rate we sell them my supply will last about two weeks on this one belt. Got plenty 800 belts.

Point was if you need one or think you will need one in the next three weeks get it now.

Todd
 
#10 ·
On approximately June 25 I put the Gates belts from Todd on my wife's RZR S and my RZR XP. We have since rode the Black Hills...approximately 400 miles total at speeds between 5-70 mph. The belts seem to be at least as good as the originals.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top